Coventry Forge Rear Wing Pair and Rear Valance Set for MGB 1962 to 1980

Panel sets rather than single panels, because these areas rot together and buying them piecemeal means cutting the car open twice. Everything here is pressed on tooling taken from original panels, in the correct gauge steel, and it is zinc coated so the repair does not start rusting from behind before the paint has hardened.

• Fitment: MGB 1962 to 1980
• Pressed in 1.0 to 1.2 mm steel to match the original gauge, not thinner sheet
• Zinc coated both faces, so the hidden side of the repair is protected
• Swage lines, drain holes and spot weld dimples reproduced in the correct positions
• Supplied as a matched set so the panel gaps and body lines actually meet
• E coat primer, ready for seam sealer and paint after degreasing
• Fitting notes and a suggested cut line diagram included

Honest advice before you order. Strip the paint and underseal back to bare metal first and find the true extent of the rot, because it is nearly always larger than it looks. Photograph the original spot weld positions and the panel overlaps before cutting anything away, and support the shell properly. A car cut apart on soft ground will never line up again.